FIGURE 1. 
STEP 1
FIGURE 1.
STEP 1
1. Leave the cartridges in the printer carriage. (This is important DO NOT REMOVE THE CARTRIDGES BEFORE YOU ATTEMPT TO REFILL). If you can take the carriage out of the printer take it out.
2. Find the original fill plug on the cartridge. This is located under the label and is approximately 3/16" round. You should be able to see the plug just under the label (as shown in diagram).
3. Using the allan wrench provided push the plug into the cartridge.
Refilling the cartridge
1. Using the syringe, draw out approximately 12ml of the desired ink.
2. Insert needle into the plug hole and inject the ink.
3. DO NOT fill the cartridge right to the top leave a little space.
4. After refilling the cartridge use the set screw provided to close the fill hole. Screw the set screw down until it is even with the cartridge.
5. Rinse out the needle in warm water and store for later use.