Epson Stylus 820, Color II/IIS, 200, 500, 1500
| 1. Seal the outlet hole(s)
in the base of the cartridge with the aluminum tape provided. A separate
piece over each hole.
2. Make vent holes using a small eyelet screw provided. 3. Fill the syringe with 5 ml. of the correct color ink. Push needle through the label into the sponge of the correct filling hole. Very slowly inject ink into the sponge until the cartridge is full. 4. Seal the vent hole(s) with the aluminum adhesive tape. If the breather holes are not sealed properly the cartridge will leak. 5. Unused ink can be returned to the bottle. Clean the syringe with warm water and dry for future use, or use with a different color ink. 6. Replace the cartridge and run cleaning cycles as per printer instructions. If necessary leave for up to 3 hours. This allows the ink to flow to the bottom of the cartridge.
|