Epson Stylus 820, Color II/IS, 200, 500, 1500
1. Seal the outlet hole(s) in the base of the cartridge with the aluminum tape provided. A separate piece over each hole is preferred.
2. Make breather holes using the eyelet screw provided in the positions shown above.<4. Push needle through the label into the sponge of the correct filling hole. Very slowly inject ink into the sponge until the cartridge is full. (This will saturate the sponge with ink and refill the reservoir)
3. Fill the syringe with 20ml of black ink. Push needle through the label into the sponge of the correct filling hole. Very slowly inject the ink into the sponge until the cartridge is full.
4. Seal the breather hole(s) with the tape provided. If the breather holes are not sealed properly the cartridge will leak.
5. Unused ink can be returned to the bottle. Clean the syringe with warm water and dry for future use, or use with a different color ink.
6. Replace the cartridge and run cleaning cycles as per printer instructions. If necessary leave for up to 4 hours. This allows the ink to flow to the bottom of the cartridge.