Chip Re-programmer	Chip Remover	Chip Carrier	Color & Black Cartridge

Step 1. Use the chip remover to pry off the chip from  the original Epson empty cartridges as shown above.	Step 2. Place the removed chip into the      carrier provided.  The chip must be put in   the carrier as show at step 2 and ready for re-programming.
Step 3 To reset the ink level to full, make sure the chip is the correct way up as show above.  Insert the chip into the re-programmer.  It takes 2-3 seconds to complete  the re-programing.  A yellow light will flash slowly if the re-programming  was successful.	Step 4        Use the chip remover again to move the chip out from the carrier.  Simply reverse the clip remover and click into the bottom of the carrier and push upward.  The chip will likely rise 45 degrees.  Fully slide the chip out of the carrier now.
Step 5 Fit the programmed clip into the cartridge and remove the seal tab.  New cartridge can be installed immediately.